Stoste Products

Si-811 Kisho Glass Coating

Si-811 Kisho Glass Coating 

 

 

Product features:
Si-811 glass coating agent, is featured with advantageous performances of enhancing finish glossiness, water repellency and anti-fouling, forming a genuine protective film to car paint. Combined practice with X-03 protectant after practice, can protect the coating film in its hardening stage, and also can effectively prevent raindrop imprint, enabling perfect glass coating effectiveness.

Si-811 Kisho Glass Coating 
【Ingredients】SiO2
【Specifications】1L、2L、4L、17L
【Dosage】One liter liquid construction34 cars, each car was 30ml
Storage method 】1. Sealed storage in shade, optimal for 4-20℃ (avoid                  
                                             high 
temperature and freezing);
                                         2. Please store out of the range within children touch. 

 




1. Drip Si-811 glass coating agent to coating sponge for 7-10 drops, first swear it laterally, then swear it vertically with "#" pattern, recommended at 50cm*50cm for each practice area, and note the usage quantity, since excessive usage per time may lead to non-uniform smearing or wiping obstruction; 


2. Wait 2-8 minutes to wipe after smearing, first use a wet towel to wipe with even strength (no need to wipe repeatedly, just spread the glass coating agent), then immediately use a dry towel to wipe the glass coating layer, until the surface is bright and smooth. Wiping duration recommendation: 30℃=within 3 min, 20℃=within 5 min, 10℃=within 8 min, glass coating hardening rate is directly correlated with temperature and humidity, thus it is recommended to measure local temperature and humidity before determining the wiping duration; 


3. Check wiping omission for each part under completion, until the whole vehicle is covered. 

4. Single practice of glass coating effectiveness is well enough, nevertheless the second practice will increase thickness and durability of coating film, in this case please exercise the second practice after previous one no sooner than 1-2 hours.
5. Upon completion of practice, perform subsequent practice according to X-03 protectant practice procedures.



Note:
1. Do not smear the whole vehicle by one time, to avoid difficulty of post-hardening treatment, please carry out practice part by part;
2. While wiping dry, observe the surface in well lighted location, to avoid remaining residue, and if indoor illumination is inferior, drive the vehicle outdoor to conduct inspection and wiping in full range, to ensure perfect practice quality;
3. After practice, complete hardening of the coating film requires around 1 week, thus do not engage water or rinse the vehicle before complete hardening;
4. This product is a mild irritant to human body, please wear protective gloves if allergic with its practice.